Calibrated Z-axis, 0 table at bottom, thread under tension +Z is up
Can't figure out why it is different from your build?
Your python program sets table start at 151.
If I change the 151 in the python code in wally segmentize.py to 120
I get errors and no output generated
I am using the 05mm-thin-wall.stl calibration item as input (20x20x10 hollow cube 1 layer wall)
Using Slic3r with your Slic3r.ini file (Slic3r.Wally_0.3.ini)
The slic3r.ini when loaded doesn't seem to populate all the configuration settings?
With my extruder extender and Bed build-up I'll never be able to
use max table height of 151, so I need a fix
