Stepper Motors

Stepper Motors

Postby jnj » Thu Dec 12, 2013 5:45 pm

Hi guys,

Wally calls for 40mm motors, but I can only seem to find them in 48mm (with reasonable shipping to Canada). My question is: how difficult would it be to make the parts work with 48mm motors?

Alternatively, does anyone happen to know a place that carries the correct motors and will ship to Canada?

Thanks,
Jeremy
jnj
 
Posts: 5
Joined: Thu Dec 12, 2013 5:38 pm

Re: Stepper Motors

Postby Cozmicray » Thu Dec 12, 2013 5:54 pm

Stepper motors Overall Dimensions 42mm x42mm x 38mm

http://www.ebay.com/itm/5-Nema-17-Mineb ... 27d28c692c

only 38mm but that works

I don't know why Wally needs 40mm motors
they just hang down below motor mounts?

:?:
Cozmicray
 
Posts: 126
Joined: Tue Dec 03, 2013 10:23 pm

Re: Stepper Motors

Postby Nicholas Seward » Thu Dec 12, 2013 6:36 pm

Use whatever size you like. I have very specifically places holes to let the wires go from the front to the back and then down guides in the back board. It would be a simple matter to drill a hole and use any size that you want.
Nicholas Seward
 
Posts: 738
Joined: Mon Nov 25, 2013 10:41 pm

Re: Stepper Motors

Postby smooshed » Sat Dec 14, 2013 4:13 pm

Just wanted to verify a few things about stepper motors -

Prototype uses the QU-BD NEMA 17 extruder motor for all four motors?

If this is true, then my understanding is that the motor is a WANTAI with custom windings, higher voltage rating (less current) and more torque than the typical stock motor of that size.

Does Wally X/Y or Z benefit from the extra torque?

There are motors from WANTAI or ROBOTDIGG with same frame length but lower voltage/torque that are available on ebay or aliexpress for about half the price, if you can wait for shipping from China.
smooshed
 
Posts: 15
Joined: Sun Dec 08, 2013 2:11 pm

Re: Stepper Motors

Postby Nicholas Seward » Sat Dec 14, 2013 5:45 pm

Those should all be great.
Nicholas Seward
 
Posts: 738
Joined: Mon Nov 25, 2013 10:41 pm

Re: Stepper Motors

Postby fezick » Fri Jun 05, 2015 12:53 am

Is there a specific shaft length that we need for the X and Y steppers? I feel like I heard something about a longer shaft needed but haven't been able to find that information again.
fezick
 
Posts: 1
Joined: Tue Jun 02, 2015 12:59 am

Re: Stepper Motors

Postby Nicholas Seward » Fri Jun 05, 2015 6:02 am

I can't imagine the shaft length ever causing a problem.
Nicholas Seward
 
Posts: 738
Joined: Mon Nov 25, 2013 10:41 pm


Return to Wally

Who is online

Users browsing this forum: No registered users and 1 guest

cron