Screws placement
16 posts
• Page 2 of 2 • 1, 2
Re: Screws placement
by Nicholas Seward » Wed Jan 29, 2014 1:28 am
@Guizmo: I use an M3 on the eccentric stop.
- Nicholas Seward
- Posts: 738
- Joined: Mon Nov 25, 2013 10:41 pm
Re: Screws placement
by tommythorn » Wed Jan 29, 2014 2:08 am
Sorry, are the M3X8s and M3X20s screws, bolts, ..? (I assume they aren't SHCS). What can I say, I'm new to this.
- tommythorn
- Posts: 90
- Joined: Tue Dec 03, 2013 12:14 am
- Location: Silicon Valley, CA, USA
Re: Screws placement
by Nicholas Seward » Wed Jan 29, 2014 2:39 am
SHCS=Socket Head Cap Screw
HHCS=Hex Head Cap Screw
All my M2 and M3s are SHCS. All the M8s are HHCS.
To me bolts are usually machine screws. On the other hand when I hear screw I don't know if it is a wood screw or a machine screw.
HHCS=Hex Head Cap Screw
All my M2 and M3s are SHCS. All the M8s are HHCS.
To me bolts are usually machine screws. On the other hand when I hear screw I don't know if it is a wood screw or a machine screw.
- Nicholas Seward
- Posts: 738
- Joined: Mon Nov 25, 2013 10:41 pm
Re: Screws placement
by imrahil » Wed Jan 29, 2014 9:46 am
Guizmo wrote:Besides that, I don't see the limit switch and screws.
other side of motor arm
- Motor arm v2 - desc.png (96.1 KiB) Viewed 30739 times
- imrahil
- Posts: 68
- Joined: Thu Dec 12, 2013 10:19 am
Re: Screws placement
by Guizmo » Wed Jan 29, 2014 2:52 pm
Nicholas Seward wrote:@Guizmo: I use an M3 on the eccentric stop.
Sorry, my mistake
- Guizmo
- Posts: 102
- Joined: Tue Dec 03, 2013 3:10 pm
Re: Screws placement
by imrahil » Fri Jan 31, 2014 2:37 pm
exploded hub
- Hub_desc.png (51.73 KiB) Viewed 30711 times
- imrahil
- Posts: 68
- Joined: Thu Dec 12, 2013 10:19 am
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 2 guests