Print starting home

Re: Print starting home

Postby Nicholas Seward » Mon Jun 16, 2014 6:54 am

DO NOT USE THE DELTA CONFIGURATION IN MARLIN. (Unless you can rewrite the firmware and come up with a calibration scheme.) Treat GUS as a Cartesian bot. Also, you can get by without ever using a G28.

#APPROXIMATE Z DISTANCE FROM SHOULDER ARM ATTACHMENT
#TO HUB ARM ATTACHMENT
BED_Z=70

↑ The first layer is the parameter to decide?
But it is not high :ugeek:

Let's get it moving and homing before we get into how Segmentize works. (However, there are some thread post on that if you want to read ahead.)
Nicholas Seward
 
Posts: 738
Joined: Mon Nov 25, 2013 10:41 pm

Re: Print starting home

Postby zxcv555578 » Mon Jun 16, 2014 5:06 pm

Nicholas Seward wrote:DO NOT USE THE DELTA CONFIGURATION IN MARLIN. (Unless you can rewrite the firmware and come up with a calibration scheme.) Treat GUS as a Cartesian bot. Also, you can get by without ever using a G28.

#APPROXIMATE Z DISTANCE FROM SHOULDER ARM ATTACHMENT
#TO HUB ARM ATTACHMENT
BED_Z=70

↑ The first layer is the parameter to decide?
But it is not high :ugeek:

Let's get it moving and homing before we get into how Segmentize works. (However, there are some thread post on that if you want to read ahead.)

Homing problem solved. The Z axis origin how to set the print?
senmentize needs to set? I got the wrong G code
zxcv555578
 
Posts: 82
Joined: Sun Jun 15, 2014 9:50 am

Re: Print starting home

Postby zxcv555578 » Tue Jun 17, 2014 6:56 am

There was an error when printing started!
The Z axis is too moving down, nozzle impinging on a hot bed.
zxcv555578
 
Posts: 82
Joined: Sun Jun 15, 2014 9:50 am

Previous

Return to GUS Simpson

Who is online

Users browsing this forum: No registered users and 1 guest

cron