Boston, MA USA Build Log

Re: Boston, MA USA Build Log

Postby Dpharris » Sun Nov 30, 2014 9:15 pm

My Two-Up finally arrived last week and I am in the process of building it. :-/
I have another set of motors, the electronics, and some hot-end bits from QUBD.
I plan to build another 3D printer, too. Which of Nicholas's creations I am not sure, yet :-)

David
Dpharris
 
Posts: 22
Joined: Wed Dec 04, 2013 12:44 am

Re: Boston, MA USA Build Log

Postby tommythorn » Fri Dec 05, 2014 6:17 pm

That mirrors my situation exactly, but I have a ~ 8 month lead on you. I have some experience to share. If you care, send me a personal message. Some of my work is here http://www.thingiverse.com/tommythorn/makes
(I strongly recommend an E3D hotend; the anUBIS is an exercise in frustration).
tommythorn
 
Posts: 90
Joined: Tue Dec 03, 2013 12:14 am
Location: Silicon Valley, CA, USA

Re: Boston, MA USA Build Log

Postby GrahamHolt » Tue Mar 17, 2015 1:38 pm

Picking this up again. Wired some endstops and I'm going to re-print the hub parts in ABS, so that is starting this morning. They will be boring old black, but that's OK if I can get it to run.
GrahamHolt
 
Posts: 51
Joined: Thu Apr 03, 2014 6:55 pm

Previous

Return to GUS Simpson

Who is online

Users browsing this forum: No registered users and 1 guest

cron